Cryogenic Vaporizers with Regulation & Control Skids

Technical Data

MODEL Cryogenic Vaporizer Model 
TYPES OF VAPORIZATION/RE-GASIFICATION   Cryogenic Vaporization Skids with Flow & Pressure Regulation
 OPERATING FLUIDS LOX, LIN, LAR, LNG, LCO2 etc.
CAPACITY OF EACH VAPORIZERS MODULE 10 to 2000 Nm3/ Hour & Higher on request
PRESSURE RANGE 1 bar(g) to 95 bar(g) as standard & higher on request
VAPORIZER CONSTRUCTION All aluminium or aluminium with SS lining
DESIGN CODES ASME
U stamp, CE marking offered on request
PRESSURE DROP OPTIONS Apart from standard pressure drop ultra-low pressure drop. All parallel units are also available on request.
MULTIFOLD CONFIGURATION  Single pass all series, parallel series combination, all parallel manifolding
FRAME CONSTRUCTION  Aluminium alloy 6061 T6, SS304 (CS on request), DNV approved frame on request.
FIN MODULATION 4, 8 & 12 fins precisely placed in different heating zons for maximised modular vaporization

CRYOGAS provides extremely portable, flexible, all-inclusive Cryogenic Vaporization Skids with required regulation and pressure control on the very same vaporizer frame.

Historically, gas companies carry out installation at customer site with tank, number of pumps, number of Vaporizers, Interconnecting piping, etc.  Such installations require a lot of time and experienced engineers to ensure compliance, safety and technical suitability.  For last 5 years, CRYOGAS gas provides Ambient Cryogenic Vaporizers with required inlet and outlet valves, safety systems, thermal relief Valves, Instrumentation, Transmitters and sensors “all-inclusive design”, completely simplified installation as a unit package.

Now just installing modules of banks of vaporizers and skids with prefabricated interconnecting piping, it is possible to erect and commission cryogenic station within a matter one only.

Since the skid along with all its piping is pretested at the manufacturing shop, only a few joints need to be tested before commencing operations.  Apart from reduction in the total cost of installation this also saves any possible negligence in Cryogenic Systems handling right from the design stage and also provides applicability to the industrial gas companies to remobilise the installations.

Preferential placement of fins i.e. 4, 8 and 12 in different vaporization zones ensure maximization of vaporizer capacity, at the same time use aluminium mass at the right place, reduce defrost cycle time and enhance super heating.

Inquiry